Cisco 7800 Series Phones - Quick Start – Parsippany-Troy Hills Township Schools

Install Your New Cisco IP Phone 7800 Series Multiplatform Phone

Your phone comes with everything you need to power it up, connect it to the network, and set it up on your desk.

After the phone connects to the network, the phone startup process begins, and the phone registers with the server.

After the phone connects, it determines if a new firmware load should be installed on the phone.

You can't adjust the Cisco IP Phone 7811 footstand.

If you'd like to see a graphic overview of these steps, see the Cisco IP Phone 7800 Series Installation Guide.

1	Plug the long, straight end of the handset cable into the phone and plug the other end into the handset.
2	Connect the network cable from your network to the network port on the phone.
3	Connect the footstand and adjust the angle of the phone. Insert the curved connectors into the lower slots. Lift the footstand until the connectors snap into the upper slots. You may need to exert more force than you expect to connect or disconnect the footstand. Adjust the angle of the phone.
4	Monitor the phone startup process. This step verifies that the phone is configured properly.
5	Allow the phone to upgrade to the current firmware image.
6	Make calls with the phone to verify that the phone and features work correctly.